Ball Gag DIY
How to make a ball gag
Ok, so you want to use a ball gag to shut your sub up, but don't want to spend a bunch of money on it?
Of course it isn't a fail-proof design, but hey it (almost) doesn't cost a dime so here's what to do:
| Materials Required: |
|
| Time to Make: |
|
Instructions:
Step 1.
Thread the cord through the ball. If you are making the solid ball gag you need to bore a hole in the ball first; make this hole only slightly bigger than the diameter of the cord.
Step 2.
Thread the cord clip onto the cord (these cord clips are the type that you find on the bottom of some rain coat draw strings). I bought mine in an army surplus store for a piddling 60 pence!
Step 3.
To finish it off tie the ends of the cord off (a reef knot or similar will suffice). I finished mine with a chrome ferral (sort of like a tube that you squish with pliers).
To Use.
This is the best bit! You slip it over your sub's head, and just zip that cord clip up tight to the back of their head. To release the gag, just press the button in and zip it back away from the sub's head. Putting the gag on and taking it off can be done in just a couple of seconds! I made my dribble gag for less than £1:50, so what's stopping you - heh heh.
the end result :-D
other ideas:
-Take a small wooden cilinder, drill 2 holes trough each side. (make sure the wood is SOFT and doesn't splinter!)
-Drill a hole as wide as the diameter of the cilinder though a rubber ball.
-Fit the two together, so that the rubber ball is in the center of the wooden cilinder.
-Attach two keychain-like rings on the sides of the cilinder. That's it :-)
-Now all you have to do is tie the ball gag to a sub with some rope, rubber bands or other material, a choice which i shall leave to your own creative and sadistic minds ;-)